Folding The Stroller - WONDERFOLD W4 2.0 ELITE Instrucciones De Ensamblaje

Operation
Securing the Harness
1. With harness unbuckled, place child in seat.
2. Secure child with harness by placing shoulder and waist belts over shoulders and
over thighs. Snap buckle tongues into center strap buckle.
3. Adjust each strap by pulling on the free end of the strap and move the
slide adjuster along strap.
Shoulder Belts
Two-Seater Layout
Single Seat Layout
Waist Belts Center Strap
Assembly & Removal of the Harness
1. Open the Velcro strips on the backside/bottom of the seat to access the belt catches.
2. Insert the belt catch perpendicularly through the front fabric and internal plastic
board as shown in diagram 2.
3. Rotate the belt catch parallel to the backrest and pull
the belt to secure in place as shown in diagram 3.
4. To remove the safety belt, rotate the belt catch perpendicularly to the backrest,
and then pull the belt and catch out.
Note: Refer to "Securing the Harness" section above for waist and center strap buckle assembly.
8
Parking Brake Operation
1. Step down gently on the parking brake pedal to lock. To test and ensure the brake is
engaged, try to push the stroller forward.
2. Lift the parking brake pedal upwards with your foot to release it.

Folding the Stroller

1. Flip the side pockets into the stroller.
2. Stand in front of the stroller, gently release the upper lock on the right hand side.
3. Grasp the folding hinge on both sides.
4. Lift up on the folding hinges with both hands until the stroller is completely folded.
Keep fingers clear of hinges to avoid pinching.
5. Secure the lower latch to lock the stroller in the folding position.
Canopy Storage
1. Adjust the handle tube to the upright direction.
2. Roll up the canopy fabric around the horizontal part of the canopy poles.
3. Insert the combined ends of the canopy poles into the storage pocket on each side of the basket.
4. Secure the poles using the straps on the rear leg tubes and snap the fasteners.
9