Description Of The Washing Machine; Control Panel - Hotpoint ARTXD 129 Manual De Instrucciones

Description of the washing
machine

Control panel

GB
ON/OFF button : press this briefly to switch the machine
on or off. The START/PAUSE indicator light, which flashes
slowly in a green colour shows that the machine is switched
on. To switch off the washing machine during the wash cycle,
press and hold the button for approximately 2 seconds; if
the button is pressed briefly or accidentally the machine will
not switch off. If the machine is switched off during a wash
cycle, this wash cycle will be cancelled.
WASH CYCLE SELECTOR buttons: used to set the desired
wash cycle (see "Table of wash cycles").
MEMORY button: press and hold the button to store a
cycle with your own set of preferences in the memory of
the machine. To recall a previously stored cycle, press the
MEMO button.
FUNCTION buttons: press the button to select the desired
function. The corresponding indicator light on the display
will switch on.
SPIN button : press to reduce or completely exclude the
spin cycle - the value is indicated on the display.
TEMPERATURE button
rature: the value will be shown on the display.
CONTROL PANEL LOCK button
panel lock, press and hold the button for approximately 2
seconds. When the symbol
panel is locked.
16
All manuals and user guides at all-guides.com
ON/OFF
button
WASH
CYCLE
MEMORY
SELECTOR
Button
Buttons
DELAYED
START
Button
: press to decrease the tempe-
: to activate the control
is illuminated, the control
CONTROL
SPIN SPEED
PANEL
Button
LOCK
Button
DISPLAY
FUNCTION
TEMPERATURE
buttons
Button
This means it is possible to prevent wash cycles from being
modified accidentally, especially where there are children in
the home. To deactivate the control panel lock, press and
hold the button for approximately 2 seconds.
DELAYED START button
time for the selected wash cycle. The delay time will be shown
on the display.
START/PAUSE button with indicator light: when the gre-
en indicator light flashes slowly, press the button to start a
wash cycle. Once the cycle has begun the indicator light will
remain lit in a fixed manner. To pause the wash cycle, press
the button again; the indicator light will flash in an orange
colour. If the symbol
opened. To start the wash cycle from the point at which it
was interrupted, press the button again.
Standby mode
This washing machine, in compliance with new energy saving
regulations, is fitted with an automatic standby system which
is enabled after about 30 minutes if no activity is detected.
Press the ON-OFF button briefly and wait for the machine
to start up again.
Consumption in off-mode: 1 W
Consumption in Left-on: 1 W
START/PAUSE
button with indicator light
: press to set a delayed start
is not illuminated, the door may be