SYMPTOM
POSSIBLE CAUSE
1. Light switch is turned off.
Light will not
2. Bulb is loose or burned out.
come on.
3. Fuse is blown or circuit
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if
Light comes
1. Light Control may be in-
on in daylight.
2. Light Control is in Test. (Set
TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide.
breaker is turned off.
(recheck after dark) .
this is a new installation.
stalled in a relatively dark
location.
control switch to an ON-
TIME position.)
SYMPTOM
POSSIBLE CAUSE
Light comes
1. Light Control may be sens-
on for no ap-
parent reason.
Light stays
1. The sensor is pointed toward
on continu-
ously.
Light flashes
1. Light Control is in the Test
on and off.
6
ing small animals or auto-
mobile traffic (Reduce sen-
sitivity) .
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface.
(Reduce sensitivity.)
mode and warming up.
(Flashing is normal under
these conditions) .
595-5770-01