Care And Cleaning; Troubleshooting - HAMPTON BAY HB-4305-BK Guía Para El Uso Y Cuidado

Operation (continued)
6
Using manual mode
NOTE: Manual mode overrides the motion sensor (C) and
"ON-TIME" control so the light will operate full bright. This
feature only works at night and only for one night at a time.
The motion sensor (C) will reset to motion sensing mode
after 6 hours or sunrise, whichever comes first. Manual
mode can be toggled on and off using a wall switch.
To turn manual mode on, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.
To turn manual mode off, switch the light off
at the wall switch for 1 to 3 seconds and then
back on.

Care and Cleaning

To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come on.
The light comes on during
the day.
Possible Cause
The light switch is turned off.
The fuse is blown or the circuit
breaker is turned off.
Bulbs are loose or burned out.
Daylight turn-off (photocell) is in
effect.
The circuit wiring is incorrect (if this
is a new installation).
The outside air temperature is close
to the same as a person's body
heat.
The motion sensor may be installed
in a relatively dark location.
The "ON-TIME" switch is in the
"TEST" position.
10
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
Turn the switch
OFF for 1 to 3
seconds
Solution
Turn the light switch on.
Replace the fuse or turn the
circuit breaker on.
Inspect bulbs and replace if
needed.
Recheck after dark.
Verify the wiring is correct.
Increase the "Sensitivity"
setting.
The light fixture is operating
normally under these
circumstances.
Set the "ON-TIME" switch to the
1, 5, or 10 minute setting.
Turn the
switch
back ON