Configuring - BYK LC 3 Instrucciones De Operación

Configuring

Baud
4 0 8 0
1 n T 3
Time
d 1 8 0
A r n
Y E S
ARng
t 2 5
Tref25
S/
cm
C o n d
0 0 9 4
Day.Month
10
All manuals and user guides at all-guides.com
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
! Switch off the measuring instrument.
! While pressing the <M> key, press <
! Select the required Baud rate with <L> <M>.
Selection: 1200, 2400, 4800, 9600 Baud.
! Then press the <RUN/ENTER> key.
! Set the required calibration interval with <L> <M>.
Selection: 1... 180... 999 d.
! Then press the <RUN/ENTER> key.
! Switch the automatic measuring range selection AutoRange on/off with
<L> <M>.
Selection: YES (On), no (Off).
! Then press the <RUN/ENTER> key.
! Switchover the reference temperature of the conductivity with <L> <M>.
Selection: 25 °C (Tref25) and 20 °C (Tref20).
! Then press the <RUN/ENTER> key.
! Switch the units of the conductivity display on/off with <L> <M>.
Selection: S/cm, MΩ
! Then press the <RUN/ENTER> key.
! Select the date and time step-by-step with <L> <M>. In between, press
the <RUN/ENTER> key each time.
! When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
>.
⋅
cm.
BYK LC 3