Steps For Installation; Installing Your Washer - Haier XQB60-91BF Manual Del Usuario

All manuals and user guides at all-guides.com
XQB60-91BF MANUAL 10/22/01

Steps for Installation

Installation Pre-Requirement:
• Select a suitable location for the washer on a hard even surface away from direct
sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.
• Any floor unevenness should be corrected with the leveling legs located on the
bottom corners of the washer.
• The washer must be placed at room temperature. You must not place washer
where the temperature is at below freezing.
Installing the Bottom Panel:
The purpose of the bottom panel installation is to block the noise and give you quite
performance of the washer during the operation.
Steps:
1. You must first lay down the washer on its rear side.
2. Insert the panel to the bottom of the machine.
3. Get a screwdriver to tighten the screw in the hole of the panel and the unit at the
bottom of the washer. (8 screws are supplied)
4. Once all screws are installed and the panel is set properly, return the washer to
its standing position.

Installing Your Washer:

Read install instructions carefully before installation.
1. Connect the hot and cold water inlet hoses to the hot and cold water faucet.
2. Connect the other end to their respective washer inlet located at the rear top of
the machine.
11:42 AM Page 25
English
24