JAROLIFT TDRC01H Instrucciones Originales página 14

PROGRAMMING
To set the end positions of the controlled radio drive and for further settings or programming steps, you need the instructions
for the respective radio motor or external radio receiver!
INITIAL PROGRAMMING - TDRC01H
The example shown is exemplary and depends on the respective receiver type� Please refer to the instructions of the
receiver!
NOTE: Each key must be pressed (held) for approx� 1 second!
Each programming step must take place within approx� 10 seconds�
Otherwise, the system automatically exits the programming mode� If necessary, start from the beginning�
1. Set the desired radio receiver or radio motor to programming mode according to the associated instructions.
2. Within approx. 10 seconds, press the up and down buttons of the hand-held transmitter simultaneously.
3. Then immediately press the stop button on the hand-held transmitter.
4. Successful teach-in is acknowledged by a short vibration of the tubular motor connected to the radio receiver or the vibrati
on of the radio motor.
Set the receiver to programming
mode Set the receiver to program-
ming mode.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the hand-held transmitter.
If the direction of rotation of the motor is incorrect (roller shutter / motor moves downwards when the UP button is pressed),
the direction of rotation of the motor must be changed.
Please refer to the chapter "Changing the direction of rotation" of the respective radio motor or radio receiver�
14
max. 10 sec.
Press the up/down
button press.
Press the stop button.
(engine vibrates)