Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Fax +1 305 430 9692
BATTERY REPLACEMENT
Your appliance contains a rechargeable battery. It can be
•
recharged many times and has a long lifespan.
The appliance is powered by Ni-Mh batteries. These batteries
•
need to be recycled or disposed of properly, in consideration of
the environment.
The batteries are user-serviceable, provided that the user does
•
not attempt to replace the batteries used in this product by any
other type of batteries. Use only the batteries supplied with this
unit or by the manufacturer as a replacement part.
In order to replace the battery, please refer to the section above
•
"BATTERY INSTALLATION AND REMOVAL".
TROUBLESHOOTING
Problem
Red LED stays after
1
power on
Vacuum on but can not
collect dirt and hair
2
The product is moving
backwards after being
3
started
LED indicators flash in
4
blue after 4hrs charging
The side brushes are
crooked, not efficient
5
to sweep
The cleaner does not start
6
7
The cleaner circles
around only, cannot go
straight
Copies of the I/B. Please reproduce them without any
changes
except
under
special
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Possible Cause
1. Battery charge is low
2. Main body is not on floor
1. The dust bin is full
2. The filter is not installed
correctly
1. The product is on dark colored
floor
2. Anti-drop sensor light was
covered
Power supply might been cut
off during charging
Being used for too long
1. Battery is not installed
properly.
2. Battery low.
3. The robot is in "Protected"
status
One of the wires of the
wheels might be loosened
13
Assembly page 13/32
instruction
from
Team
Print only
Solution
1. Recharge the battery
2. Re-place the robot on the
floor
1. Clean the dust bin
2. Re-install the filter
correctly
1. Put the robot on a light color
floor.
2. Clean anti-drop sensor light.
Keep charging for a little
longer.
1. Immerse brushes it in hot
water to recover it to its
original shape,
2. Replace brush
1. Install the battery correctly
2. Have the battery fully
charged(turn off the cleaner
first)
3. Re-set the robot cleaner
1. Open the wheel cover and
connect the loosen wire
properly
2. Send the robot cleaner to
seller for repair.
RVC 40540 - 120501
Publicidad
Tabla de contenido
