All manuals and user guides at all-guides.com
Fax +1 305 430 9692
USING YOUR VACUUM CLEANER
Once your appliance is fully charged, remove the charger from
•
the wall outlet and unplug the other end from the unit.
Make sure the dust bin with the filter and lid are properly installed
•
inside the main housing.
Place the unit on a flat surface to clean, ideally a hard floor.
•
Please avoid using on long hair carpets or rugs.
Switch it on by pressing the ON/OFF switch.
•
The red and blue light are blinking alternatively and the unit will
•
start moving forward and vacuuming.
Each time an obstacle is met, the unit will change direction.
•
After a while the whole room will be cleaned completely.
•
Notes:
o If the unit gets stuck against an obstacle, like a big rug, just
press gently on the bumper (6) so that the unit changes
direction and keeps vacuuming.
o The unit is equipped with a stairs detector that will stop the
unit and prohibit letting it fall down the stairs. Please note that
this feature is only activated a few seconds after the unit is
switched on, so do not start vacuuming in stairs or in high
places like a table, or the unit might fall.
Copies of the I/B. Please reproduce them without any
changes
except
under
special
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
Grooves
9
Assembly page 9/32
instruction
from
Team
Print only
FIG. 5
RVC 40540 - 120501