Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all
safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or
"WARNING." These words mean:
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you
what can happen if the instructions are not followed.
Tools and Parts
Check that you have everything necessary for correct assembly. Proper
assembly is your responsibility.
Tools Needed:
⁷⁄₁₆ in. Socket wrench
³⁄₈ in. Wrench
Parts Supplied for Locker Model:
Rigid casters (2)
Swivel casters (2)
¹⁄₄ in. – 20 Self-locking nuts (16)
¹⁄₄ in. – 20 x ¹⁄₂ in. Carriage-head
bolts (16)
Parts Supplied for Cabinet Model:
Rigid casters (2)
Swivel casters (2)
¹⁄₄ in. – 20 Self-locking nuts (16)
¹⁄₄ in. – 20 x ¹⁄₂ in. Carriage-head
bolts (16)
Cabinet/Locker Use Requirements
Intended for use in a garage.
Maximum weight limit is 50 lbs (22 kg) for each shelf, not to exceed
300 lbs (136 kg) for the cabinet/locker.
Maximum weight limit is 300 lbs (136 kg) for the cabinet/locker.
Unpack the Cabinet/Locker
NOTE: Keep the 2 rear cardboard corners. They are needed to cushion
the cabinet/locker during caster installation.
1.
Remove the keys and unlock the door.
2.
Remove and verify the contents (see "Parts Supplied" for your
model).
2
All manuals and user guides at all-guides.com
CABINET/LOCKER SAFETY
Your safety and the safety of others are very important.
ASSEMBLY INSTRUCTIONS
Phillips screwdriver
Flat-blade screwdriver
Half-width shelves (4)
Double hooks (2)
#10 – 24 x ¹⁄₂ in.
Pan-head screws (4)
#10 – 24 Nuts (4)
Keys (2)
Full-width shelves (3)
Keys (2)
You can be killed or seriously injured if you don't
immediately follow instructions.
You can be killed or seriously injured if you don't
follow instructions.
Assemble Casters
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble cabinet
or locker.
Failure to do so can result in back or other injury.
1.
Close and lock the cabinet/locker doors.
NOTE: If you need to open the cabinet/locker doors during caster
assembly, open them slowly and do not put any weight on the open
doors. This avoids damage to the hinges.
2.
Using 2 or more people, place the cabinet/locker on its back using
the cardboard corners to cushion cabinet/locker. Discard the
cardboard bottom.
3.
Insert the carriage-head bolts into the keyhole slots and slide to
narrow end, seating the bolts in place as shown.
4.
Attach the 2 rigid casters (with side brakes) to the front location and
start the 4 self-locking nuts for each caster.
5.
Hold the caster in place making sure the bolts are seated in the
narrow ends of the keyhole slots. Tighten the self-locking nuts with a
⁷⁄₁₆ in. socket wrench.
Publicidad
Tabla de contenido
