Fcc Compliance Statement - Vaisala RFL100 Manual

Regulatory Compliances

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
WARNING!
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
WARNING!
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
ISED Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
This device has a PCB integrated inverted F-antenna with a gain of 1 dBi.
Le présent appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Le présent appareil dispose d'une antenne F inversée intégrée à la carte avec un gain de 1 dBi.
CAUTION!
distance must be maintained between the user and the device when the device
is operating.
Changes or modifications to this equipment not expressly
This device complies with part 15 of the FCC Rules. Operation is
This device requires a separation distance of at least 20 cm. This
65