Publicidad
Idiomas disponibles
Idiomas disponibles
Información Técnica:
6
Gestión de residuos de envases y de productos:
9 7
MATERIAL
PLÁSTICO
PAPEL Y
CARTÓN
NOTA: El color de los contenedores puede variar en función del pais donde se aplique. Consulte la normativa local al respecto.
Instructions for use and safety
1
General view:
Normative:
2
- Follow these instructions to comply with the 2014/35/UE (DBT).
- Installation, service and maintenance of the electrical equipment may be carried out by anauthorized person only .
3
Characteristics and components:
T2- Lid assembly with metal claw T3- Lid assembly with plastic claw T4- Lid assembly with central screw. B-TYPES OF CLAW.
G1- Metal claw assembly. G2- Plastic claw assembly. C-ADVANTAGES FOR BOX MOUNTING: V1- Slots for box hole. V2- Ø
crown for box hole V3- Bottom supports for installation tubes. (TABLE) A-TYPES OF LID. B-TYPES OF CLAW. C-ADVANTAGE...
4
Assembly instructions: 1- Make a hole in a hollow partition. 2- Break windows or pre-punched bottom,
necessary. 3- Assemble claws and fix the box to the hollow partition. 4- Place installation tubes. 5- Assemble
the cover accordingly.
4-1 BOXES WITH SLOTS FOR HOLE BOX (see table, V1). ROUND BOXES FOR HOLLOW BOX (ØXX see
table, V2) 4-3 BOXES WITH METAL CLAMPS (see table, G1) BOXES WITH PLASTIC CLAMPS (see table,
G2) 4-4 BOXES WITH FLANGED SUPPORT (see table, V3). 4-5 MOUNT COVERS AS APPROPRIATE. (See
table, T1; T2; T3). T1 = Position the cover, and mount by screwing the cover screws. T2 = Position the metal
claws in their housings and press firmly. T3 = Position the plastic claws in their housings and press firmly.
5
Safety and usage tips.
6
Technical information:
7
Management of packaging and product waste: PACKAGING WASTE; MATERIAL; PLASTIC; PAPER AND PAPERBOARD;
DEPOSIT IN: (NOTE); LOGO IN SPAIN; INTERNATIONAL LOGO (NOTE); PRODUCT WASTE; WASTE; NO WEEE;
DEPOSIT IN: LOCAL RECYCLING CENTER; LOGO. NOTE: The color of the containers may vary depending on the country
where it is applied. Check local regulations on this.
Mode d'emploi et de sécurité
1
Vue d'ensemble:
La réglementation: - Suivez ces instructions pour se conformer à la réglementation basse tension 2014/35/UE (DBT).
2
- Installation, entretien et maintenance des équipements électroniques ne peuvent être effectués par une
personne autorisée.
RESIDUOS DE ENVASE
LOGOTÍPO EN
ESPAÑA
DEPOSITAR EN:
CONTENEDOR
AMARILLO
CONTENEDOR
AZUL
MADE IN SPAIN
-Dry wall installation.
Halogen Free
FABRIQUÉ EN ESPAGNE.
- GWT 850ºC
- Clasificación térmica Ha.
RESIDUOS DE PRODUCTOS
LOGOTÍPO
RESIDUOS
INTERNACIONAL
NO RAEE
Box. 2- Claw. 3- Cover. A-TYPES OF LID: T1- Lid assembly with screws.
-Thermal classification Ha.
-4-
DEPOSITAR EN:
LOGOTÍPO
ECOPARQUE
MUNICIPAL
ENGLISH
FRANÇAIS
Publicidad
