Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OVERVIEW
See FIG 1
1.
Carry Handle
2.
Light Heads
3.
Lenses
4.
Side Locking Knobs
5.
On/Off Switches
UNPACKING CONTENTS
Important!
Due to modern mass production
techniques, it is unlikely the product is faulty or that a part
is missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.
CONTENTS IN PACKAGE
Description
Light Heads
Stand with Carry Handle
Tripod
Manual
SPECIFICATIONS
Rated Power ................. 120V~, 60Hz, 70W
Brightness .................... 8000 Lumens
Color Temperature ........ 5000K Bright White
CRI ............................... >80
Cord ............................. 9 ft. 18/3 SJTW
IP Rating ...................... 65
Tripod Height ................ 24" - 48"
Net Weight ................... 9.0 lb
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL WARNINGS, CAUTIONS
AND OPERATING INSTRUCTIONS BEFORE USING THIS
EQUIPMENT. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
personal injury.
WARNING:
not use with an extension cord near water or where water
may accumulate. Keep work light at least 16 feet from
pools and spas. Keep plugs and receptacles dry. Use only
three-wire outdoor extension cords with grounded plugs
and grounded receptacles.
•
Ground Fault Circuit Interrupter (GFCI) protection
should be provided on the circuit(s) or outlet(s) to be
used for this light in wet locations. Receptacles are
available having the built-in GFCI protection and are
able to be used for this measure of safety.
•
Use only with an extension cord for outdoor use,
such as an extension cord of cord type: SW, SW-A, SOW,
6.
LEDs
7.
Stand
8.
Tripod
9.
Power Cord
Quantity
2
1
1
1
RISK OF ELECTRIC SHOCK, Do
English
IMPORTANT SAFETY INSTRUCTIONS
SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A,
SJOW, SJOW-A, SJTW, SJTW-A, or SJTOW, SJTOW-A.
•
Do not look directly at the lighted lamps to avoid eye
injuries.
•
Always keep the work light away from any
flammable surface or materials.
•
Always check damaged or worn-out parts before
using the work light. Broken parts will affect the work
light operation. Replace or repair damaged or worn
parts immediately. If repairs are needed, consult a
professional electrician.
•
Do not use a pressure washer to clean this product.
•
Do not modify the work light in any way. Unauthorized
modification may impair the function and/or safety and
could affect the life of the product. There are specific
applications for which the work light was designed.
•
Store work light in a secure place out of the reach of
children. Inspect it for good working condition prior to
storage and before re-use.
California ProPosition 65 Warning
This product can expose you to Lead and other chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Wash your hands after
handling. For more information go to www.P65Warnings.
ca.gov
ASSEMBLY INSTRUCTIONS
ATTACHING WORK LIGHT HEADS TO
THE STAND (FIG 2)
1. Place the stand (7) on a flat surface.
2. Rotate the carry handle (1) straight up. Tighten the
handle locking knob (G3) to secure it in place.
3. Install one work light head (2) on the stand (7) by sliding
and positioning the U-shape bracket (10) under the bolt
cap (G2) as shown in FIG 2. Tighten the locking knob
(G1) to secure the work light head in place. Repeat the
procedure on the second work light head.
4. Hang the power cable splitter (H) on the hook (G4).
ADJUSTING THE TRIPOD (FIG 3)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are
fully extended and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by loosening the twist
collars (C1 & C2) and raising the center poles (D1 & D2)
of the tripod. Firmly tighten the twist collars when the
tripod reaches desired height.
NOTE:
The maximum height of this tripod is 48".
3
Publicidad
