Declaration Of Conformity; Product Liability; Manufacturer's Warranty - STEINEL RS Pro 5100 SC Manual

The self-test is no substitute for the function check
prescribed in national regulations for emergency-light
illumination.
Checks by the user "(EM)"
• The LED status indicator as well as sensor-switched
luminaire must be visually checked for proper
working order once a month.
Changing rechargeable batteries "(EM)"
The rechargeable batteries must be replaced if the
emergency-light module's status LED permanently
flashes red.
• Rechargeable batteries must be changed by the
manufacturer. Customer service:
STEINEL (UK) Limited
25 Manasty Road, Axis Park
Orton Southgate
Peterborough, PE2 6UP
Service Hotline: 01733 366700
• Contact the manufacturer beforehand to make sure
that the relevant replacement luminaire is available.
Two options:
– Replacement with a sensor-switched luminaire over-
hauled by STEINEL with new rechargeable batteries
(flat-rate service charge).
– Replacement with a new sensor-switched luminaire
(concessionary purchase price).
• Then send back removed sensor-switched luminaire.
Battery regeneration "(EM)"
After starting up for the first time (also after changing
rechargeable battery or rectifying a fault) the emer-
gency-light control gear regenerates the rechargeable
batteries automatically.
Three cycles are carried out. A cycle consists of a
24-hour battery charge and full discharge via the
sensor-switched luminaire in emergency mode. Battery
capacity is not measured while cycles are in progress.
The battery regeneration process is neither carried out
after the rechargeable battery discharges in the normal
way nor after self-testing battery capacity.
Cleaning
The sensor-switched luminaire can be cleaned with a
damp cloth (without detergents) if dirty.
Important: The control gear cannot be replaced.
8. Disposal
Electrical and electronic equipment, accessories and
packaging must be recycled in an environmentally
compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste Elec-
trical and Electronic Equipment and its implementation
in national law, electrical and electronic equipment no
longer suitable for use must be collected separately
and recycled in an environmentally compatible manner.

9. Declaration of Conformity

Hereby, STEINEL Vertrieb GmbH declares that the
radio equipment type RS PRO 5100/5150 SC /
RS PRO 5100/5150 SC EM is in compliance with
Directive 2014/53/EU. The full text of the EU declara-
tion of conformity is available at the following internet
address: www.steinel.de

10. Product liability

The requirements defined in standard EN60598-1
regarding safety must be met after installing the
emergency lighting luminaire. The user of the
emergency-light control gear is responsible for
meeting this standard.
The manufacturer shall not accept any liability in the
event of failure to observe this standard.
STEINEL shall accept no liability for direct, indirect or
incidental damage resulting from improper use or use
not expressly permitted by STEINEL. STEINEL not
accept any liability either for damage claims made by
third parties on the basis of improper use or use not
expressly permitted by STEINEL. The emergency-light
control gear must not be opened or in any way mod-
ified. Components of the emergency luminaires must
only be replaced with genuine replacement parts and
by STEINEL itself.
If the emergency-light control gear shows damage
suggesting that any safety operation cannot be
ensured, the sensor-switched luminaires must not
be put into operation. STEINEL reserves the right to
change depictions, weights, dimension tables or other
such details in the catalogue or operating instructions
without notice if this is shown to be appropriate or is
the result of technical progress.

11. Manufacturer's Warranty

As purchaser, you are entitled to your statutory rights
against the vendor. If these rights exist in your country,
they are neither curtailed nor restricted by our Warranty
Declaration. We guarantee that your STEINEL Profes-
sional sensor product will remain in perfect condition
and proper working order for a period of 5 years.
– 18 –