Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the Temperature Control
This appliance is designed for mobile use (RV, Motorhome,
Camper or Vehicle) and outdoor use.
The following instructions will apply when the unit is
connected to either DC or AC power source using the
appropriate adapter.
Your unit has only one control for regulating the temperature
in the compartment.
When the unit is first plugged in, you will hear a beep and
the control panel will light up. You can select the
temperatures and settings as desired.
Display:
This display will show the set temperature while programming and then the current
temperature of each zone while operating.
Temperature Setting: Press the + or – buttons to select the desired temperature of each zone, press
the "SET" button to switch between zones. (Temperature Range -4ºF – 68ºF (-20ºC – 20ºC))
Cooling Mode (ECO / MAX):
to select the desired mode: (Factory default setting is MAX).
Max:
Normal Cooling Mode
ECO:
Energy Saving Mode
Dry Storage Mode:
To deactivate the cooling follow the steps below:
Press and hold the + and SET buttons at the same time. The display will show (- - -) to confirm the
cooling system has been disactivated.
To turn the cooling system back, please repeat the steps above. The system will return to normal
cooling process.
USB Connector: Output +5V DC/1A is suitable for temporary connection of small devices like mobile
phones, tablets etc.
System Reset:
To reset the unit to the factory default, turn off the unit by pressing the POWER
ON/OFF button, press and hold the SET button until the message E1 is shown in the display window.
Press the + and – buttons at the same time until the screen resets.
OPERATING YOUR APPLIANCE
Press the "SET" button to enter the mode selection, press "SET" again
Your unit can also serve as storage bin.
9
Publicidad
Tabla de contenido
