Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
SAFETY FUNCTIONS AND
TROUBLESHOOTING
HOOD SAFETY SWITCH
It is activated when the machine hood is lifted up: it stops
all machine functions.
In the case where the machine starts even when the hood
is open, contact an authorized Service Center or Retailer
for Service.
TROUBLESHOOTING
TROUBLE
SOLUTION
Check that the connector 3, Fig. U
is properly connected.
Check that the hood is properly
closed.
Check the circuit breaker (6, Fig.
When the key is in the "I"
U).
position, the machine does not
Check the Electronic circuit fuse
start.
(18, Fig. U) integrity
Check that the battery charger is
properly connected to the batteries
and/or the battery charger is not
plugged in to recharge the
batteries.
The side broom does not
Check the side broom fuse (7, Fig.
operate
U) integrity
The machine operates only
Re-charge the battery. If the
when stationary, otherwise the
problem persists, replace the
red warning light turns on.
battery.
Check if the main broom pattern is
not wider than 4 cm (1.57 in)
The circuit breaker (6, Fig. U)
Check that the machine is not
trips frequently.
working on slopes higher than 2%
Check if debris is not blocking the
main broom rotation
Install a battery with greater
The battery run time is low.
capacity. (Min. 140Ah)
NOTE:
As your machine has a battery charger
installed, the machine can not operate if the
charger is not on board. In case of battery
charger malfunction, contact an Authorized
Service Center.
For further information consult the Service Manual at any
Kent Service Center.
12
All manuals and user guides at all-guides.com
SCRAPPING
Have the machine scrapped by a qualified dismantler.
Before scrapping the machine, remove the following
components:
1.
2.
3.
4.
Battery
Polyester dust filter
Main and side brooms.
Circuit board
CAUTION!
The removed components must be disposed
of properly and according to all applicable
laws.
Blue 32 – 146 2301 000(1)2005-03
Publicidad
Capítulos
