Hammer Drill; Intended Use - SBM Defort DID-1055Nx2S Instrucciones De Servicio

English

Hammer drill

INTENDED USE

This tool is intended for hammer drilling in brick, con-
crete and stone as well as for drilling in wood, metal,
ceramic and plastic. Tools with electronic speed control
and left/right rotation are also suitable for screwdriving
and thread cutting
TECHNICAL SPECIFICATIONS
PRODUCT ELEMENTS
1 On/Off switch with speed control
2 Switch locking button
3 Wheel for maximum speed control
4 Switch for changing direction of rotation
5 Switch for selecting drilling function
6 Auxiliary handle
7 Switch for selecting mechanical speed
SAFETY
WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock,
Þ re and/or serious injury.
Wear ear protectors with hammer drills (exposure to
noise can cause hearing loss)
Use auxiliary handles supplied with the tool (loss of
control can cause personal injury)
Avoid damage that can be caused by screws, nails
and other elements in your workpiece; remove them
before you start working
Always keep the cord away from moving parts of the
tool
When you put away the tool, switch off the motor
and ensure that all moving parts have come to a
complete standstill
Use completely unrolled and safe extension cords
with a capacity of 16 Amps (UK 13 Amps)
In case of electrical or mechanical malfunction,
immediately switch off the tool and disconnect the
plug
SBM Group can assure ß awless functioning of the
tool only when original accessories are used
Use only accessories with an allowable speed
matching at least the highest no-load speed of the
tool
This tool should not be used by people under the
age of 16 years
Be careful not to drill or drive into areas where
electrical wires may be contacted
If the cord is damaged or cut through while working,
do not touch the cord, but immediately disconnect
the plug
Never use tool when cord is damaged; have it
replaced by a qualiÞ ed person
Always check that the supply voltage is the same
as the voltage indicated on the nameplate of the
tool (tools with a rating of 230V or 240V can also be
connected to a 220V supply)
1
2
If the drill bit becomes unexpectedly jammed (causing
a sudden, dangerous reaction), immediately switch
off the tool
Be aware of the forces that occur as a result of
jamming (especially when drilling metals); always
hold the tool Þ rmly with both hands and take a
secure stance
Always disconnect plug from power source before
making any adjustment or changing any accessory
Holding the tool
- keep the ventilation slots uncovered
- do not apply too much pressure on the tool; let the
tool do the work for you
Your machine is double insulated in accord-
ance with EN 50144; therefore no earthwire is
required.
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots
free from dust and dirt.If the dirt does not come off use
a soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
The machine requires no additional lubrication.
Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
your unwanted machines to your local SBM Group
dealer. Here they will be disposed of in an environmen-
tally safe way.
GB
7