LaserLiner SuperPlane-Laser 3D Instrucciones De Uso página 9

!
When A2 and A3 are more than 3.5 mm / 10 m apart, an adjustment is necessary.
Contact your authorised dealer or else the UMAREX-LASERLINER Service Department.
Checking the vertical line:
Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m length on the wall, making
sure that the bob can swing freely. Switch on the device and align the vertical laser to the plumb line.
The precision is within the specified tolerance if the deviation between the laser line and the plumb line
is not greater than ± 1.75 mm.
Checking the horizontal line:
Position the device about 5 m from a wall and switch on the cross laser. Mark
point B on the wall. Turn the laser cross approx. 2.5 m to the right and mark
point C. Check whether the horizontal line from point C is level with point B
to within ± 1.75 mm. Repeat the process by turning the laser to the left.
!
Regularly check the adjustment before use, after transport and after extended periods of storage.
Technical data
(Subject to technical alterations. 09.16)
Self-levelling range
Precision
Operating range (depending on room illumination)
Laser wavelength
Laser class / line laser output power
Power supply
Operating time
with 3 laser levels
with 2 laser levels
with 1 laser level
Operating temperature
Storage temperature
Weight (incl. batteries)
Dimensions (W x H x D)
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately for
disposal according to the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
SuperPlane-Laser 3D
± 3°
± 3.5 mm / 10 m
15 m
650 nm
2 / < 1 mW
4 x 1.5 V alkaline batteries (Type AA) /
rechargeable batteries
approx. 6 hours
approx. 10 hours
approx. 25 hours
0°C ... + 50°C
-10°C ... + 70°C
650 g
85 x 125 x 130 mm
2,5 m
B
C
09
EN