Attaching The Base; Adjusting The Height; Adjusting The Inclination - Fujitsu Zero Client DZ19-2 Manual De Instrucciones

Getting started

Attaching the base

Do not remove the locking pin before you have fixed the base plate on the Zero
Client and placed the Zero Client in the operating position.
► Insert the base plate on the foot (1).
► Guide the screw through the opening (2).
► Secure the base plate with the screw (3).
► Place the Zero Client in the operating position.

Adjusting the height

The height of the Zero Client can be adjusted by approximately 110 mm.
► Remove the retaining splint on the rear of the height adjustment.
► Grasp the monitor with both hands at the left and right edges of the
housing and move it up or down.

Adjusting the inclination

The monitor of the Zero Client can be tilted -3° (forwards) and +35°
(backwards) from the vertical position.
► Hold the monitor with both hands on the left and right sides of the casing
and move it to the desired angle.
Fujitsu Technology Solutions
1
2
English - 13
3
15