Roger Beep (End Of Transmission Tone) - Midland PMR446 Manual De Instrucciones

OPERATIONS
Power on/off and volume adjustment
Rotate the Power/Volume knob
you prefer.
the radio off.
Transmission
Function key 1 to enable the Monitor feature in order to
For a maximum clarity, hold the device at a distance of about 4/10 cm.
Release the PTT
Only one user at a time can talk during radio communications. Therefore,
it is important not to transmit when you are receiving a communication and
use the transmission mode sparingly to allow other users to use the feature.
be used sparingly to prolong the battery life.
If you are unable to contact a station that you have no problems in receiving,
the station may be using CTCSS tones or DCS codes.
Monitor
opened.
Function key 1 to enable such function.
Scan
Keep pressed the Function key 2 for about 4 sec. to enable the SCAN fun-
ction: the radio will scan all channels from the channel in use.
scanning, press again the PTT button.
Vox
G11
in the direction of the microphone and the communication will be automati-
cally activated.
the programming software:
9 is the highest one.
key1.
Squelch
G11
PTT button.
Make sure you do not set an excessively high squelch level because in this
case you may not be able to receive weaker signals. On the other hand an
excessively low Squelch value could enable the Squelch even when no si-
gnals are present.
Squelch must always be adjusted when no signals are present.
gramming software.

Roger Beep (end of transmission tone)

When the PTT
Beep Tone
sensitivity of G11 is set on level 5.
G11 is set on level 5.
0,1,2,3...9) trough
Function
-
-
9