Other Set - Samsung SCC-641 Manual Del Usuario

ALARM OUT
Each ALARM input corresponds to one of the 3
ALARM OUT. < The ALARM3 is designed as the
Relay OUT >
ALARM PATTERN
This sets the operation of PATTERN movements when
inputting ALARM.
When the ALARM is inputted the correspondence will
be as follows: ALARM1 input to PRESET 1, ALARM 2
input to PRESET 2, ALARM3 input to PRESET 3,
ALARM 4 input to PRESET 4, and MOTION input to
PRESET 5.
When the ALARM is working, it will stay in the PRESET
location corresponding the ALARM for the DWELL
TIME and the ALARM connected to the PATTERN will
continuously operate the PATTERN movements.
The OFF in the Setup Menu does not operate the PATTERN, and it means 1 →
PATTERN1, 2 → PATTERN 2, 3 → PATTERN 3, continuous motion of HALF1 →
PATTERN 1 + PATTERN 2, continuous motion of HALF 2 → Pattern 2 + PATTERN 3
and continuous motion of FULL → PATTERN 1+PATTERN2+PATTERN3.
AUX OUT CONTROL
This sets the ALARM OUT motion to continue or act only
when the ALARM is working.
If it is set to OFF the ALARM OUT motion will operate
only when the ALARM is set off (Active "Low"), and if it's
set to ON, the ALARM OUT will always operate
regardless of the ALARM.
3-22
All manuals and user guides at all-guides.com
ALARM OUT
ALARM1 1
ALARM2 2
ALARM3 3
ALARM4 2
MOTION 1
EXIT QUIT
ALARM PATTERN
ALARM1 OFF
ALARM2 OFF
ALARM3 1
ALARM4 2
MOTION 3
EXIT QUIT
AUX OUT CONTROL
OUT1 OFF
OUT2 OFF
OUT3 ON
EXIT QUIT

OTHER SET

AC(Auto Calibration)
This function turns on or off Auto Calibration. SCC-C641(P) has the Auto Calibration
function to improve the precision of LENS and PAN/TILT motor.
You may set to OFF/6HOUR/12HOUR/18HOUR/24HOUR. Without user's key input for
the time designated by the user, A.C. will appear on the screen while initializing LENS
and PAN/TILT.
P.P/T(Proportional PAN/TILT)
This function controls the PAN/TILT speed to the ZOOM magnification ratio during the
manual operation of PAN/TILT. If you set PROPORTIONAL P/T to ON, the PAN/TILT
speed will increase in the ZOOM WIDE mode and decrease in the ZOON TELE mode
even in the same manual operation.
HOME RETURN
When there is no KEY input or other movement for a certain time, the camera moves to
the HOME location automatically. The HOME location can be assigned from the HOME
POSITION menu.
SET UP TIME FOR HOME RETURN:
OFF: HOME RETURN function cancellation
© © ©
OFF 1 MIN 2 MIN 3 MIN ~ 60MIN
HOME POSITION
You can select the HOME POSITION from the preset positions numbered between 0
and 127.
AUTO FLIP
When operating the Tilt to the 90° limit using the Joystick, the camera PAN automatically
revolves 180° showing the opposite area of the Tilt area.
It gives the effect of extending the Tilt operating area 180°.
©
~12HOUR
3-23
E