Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
2" x 2"
Figure 2
1.
Lower exhaust muffler: Use soapy water to lubricate exhaust rubber hangers. Using exhaust removal pliers, remove rubber hangers at (3) rearmost locations. Note: Be sure to
support exhaust before removing rubber hangers.
2.
Trim panels: Using tape and marker, sketch a 2" x 2" square on inside corner of panel under vehicle, both sides. Using die grinder, remove 2" x 2" corner, both sides, see Figure 2 and
Figure 3.
3.
Install hitch: Use wire brush to clean paint and debris from weldnuts. Raise the hitch into position and secure hitch to vehicle with (3) M12 bolts ① and (3) 1/2" conical washers ②,
both sides, see Figure 1. Note: If necessary, firmly press heat shield up to keep from contacting top of hitch.
4.
Tighten all M12 fasteners with torque wrench to 76 Ft.-Lb. (103 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5.
Reinstall the rubber hangers and exhaust muffler.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2021 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76543, 84543, CQT76543
Frame Rails
Existing Weldnuts
Conical washer
teeth side
against hitch
①
②
Figure 1
Fasteners
typical
both sides
Sheet 3 of 12
76543NP
Fastener Kit: 76543F
Qty. (6)
Bolt
M12 x 1.25 x 45 CL 8.8
Qty. (6)
Conical Washer
1/2"
2" x 2"
Figure 3
11-08-21
Rev. A
Publicidad
