Memory Function; Cleaning And Storage - Beurer EM 29 Instrucciones De Uso

• Check that the electrodes are OK and do not show any
signs of damage.
• Check that the round cover is still on the electrode con-
nections.
• Remove the cuff and moisten it again completely.
• When you put it back on, ensure that there is good con-
tact with the skin and that the skin is damp.
Pausing a program
If you want to pause a program while it is running, press
the Pause button [1]. An acoustic signal sounds and the
pause symbol "II" flashes in the display [6]. The program
can be continued by pressing the button [1] again.
Contact detection
If the electrodes are not in contact with the body, the inten-
sity will automatically be set to zero. This prevents unwant-
ed electrical stimulation. The intensity cannot be increased
if the electrodes are not in contact with the body.

Memory function

The device saves the last program that was set.
After replacing the battery, the device starts again with the
first program.

7. Cleaning and storage

Cleaning the control unit
Important
Before beginning the cleaning process, disconnect the con-
nection cable from the control unit and the universal cuff and
remove the batteries.
Clean the control unit after use with a soft, slightly damp
cloth. If it is very dirty, you can also moisten the cloth with
a mild soapy solution. Do not use any chemical or abra-
sive cleaning agents. Ensure that no water gets inside the
control unit.
Cleaning the universal cuff
Important
1. Before beginning the cleaning process, disconnect the
connection cable from the universal cuff.
2. Clean the universal cuff carefully in lukewarm, soapy wa-
ter. Do not use hot water. Afterwards, rinse it well with
water so that no soap remains on the universal cuff.
3. Then carefully pat the universal cuff dry with a towel and
leave it to dry.
27