Installing; Installing Of Outdoor Station (Camera); Installing Of Monitor - Extel MEMO Instrucciones De Uso E Instalación

All manuals and user guides at all-guides.com
4

INSTALLING

a. Installing of outdoor station, exterior camera
1. Remove the screw cover (1) and unscrew the 2 screws (3)
2. Fix the shield (4) taking care to let pass the cable coming from the monitor and the opening.
3. Connect the cable as shown in the wiring diagram
4. Hang the outdoor station on the pin (6) of the shield, and fix the whole using the screw (2)
5. Replace the screw cover (1) and the 2 screws (3).
Make sure that the camera lens is not pointing directly at the sun or at a reflective surface.
Important !
Seal the upper joint between the exterior plate and the wall with silicone (5)
b. Installing of monitor
1. Put the wall carrier (2) in place.
2. Connect the wires coming
from the outdoor station.
3. Connect the adaptor plug (3)
to the back of the monitor (without
connecting it to the power supply).
4. Fix the monitor (1) to the wall
carrier (2).
5. Check that the installation iscomplete
and connect the adaptor to the
power supply.
N.B. : If the power supply cable is cut, check the polarity (black wire and black wire with grey edging)
CFI EXTEL MEMO - 09/2010 - V1 5GB