Uline H-6745 Instrucciones De Montaje página 4

3
Figure 4
7
6
Frame
Header
Figure 6
8
PAGE 4 OF 12
ASSEMBLY CONTINUED
5. Insert rear legs (3) into outside corner between the
6. Place door and frame assembly (6 and 7) over
7. With two people, being careful not to put all the
JOINING UNITS TOGETHER
Figure 5
1. If joining a unit beside another unit, temporarily
2. With two people, being careful not to put all the
Frame
Sill
SECURING UNITS
1. Anchor units to wall or floor. Units are not intended
2. Use supplied leveling feet and hardware (8) to level
1-800-295-5510
uline.com
bottom and the side. Bolt leg to side using two bolts
and nuts per leg. (See Figure 4)
the locker body. Attach top to frame header and
bottom to frame sill (one bolt each). (See Figure 5)
If joining a unit beside another unit skip to
JOINING UNITS TOGETHER.
weight on the rear legs, stand unit upright and
place in desired location. Check and tighten all
permanent bolts.
install a bolt and nut into the third and sixth holes
down from the top of the outer frame(s) that
will be joined to the adjacent locker frame(s).
(See Figure 6)
weight on the rear legs, stand units upright and
place in desired location. Remove bolts placed
temporarily. Using those bolts, bolt adjacent units
together through frames. Check and tighten all
bolts.
NOTE: If the bolts placed temporarily are not
removed before the frames are joined side by
side, the frames will have a 1/8" gap between
them.
to stand free and may topple if not secured. (Units
standing back to back should be bolted together.)
CAUTION: Care must be taken to ensure
that lockers are set plumb and true before
anchoring.
the unit. (See Figure 6)
0321 IH-6745