Operation - Cameo UVO Manual De Usuario

OPERATION

A few seconds after connecting to the mains, the effect-spotlight is ready for operation and the previously selected operating mode is
activated. During the startup process, the software version is displayed briefly (Vxxx).
ACTIVATING DMX-CONTROL, CONFIGURING DMX MODE AND DMX START-ADDRESS
Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo). Using the UP and DOWN buttons,
select the menu item "ModE" and confirm with ENTER and then select dmX" (display LED "DMX" will light up). Confirm with ENTER, then
select the desired DMX mode using the UP and DOWN buttons (03ch, 05ch, 12ch, 19ch, 32ch) and confirm selection with ENTER Now the
DMX start address can be configured, again by using the UP and DOWN buttons (the highest configurable DMX start address is dependent
upon the selected DMX mode). Confirm with ENTER. All four characters in the display will flash if no DMX signal is present. If a DMX signal is
present, the flashing will stop. The DMX LED will light up if DMX-mode is activated. Synchronous control of several lamps of the same model
with a DMX controller (e.g. DMX console) can be achieved by configuring the lights with the same DMX mode and the same DMX start
address and connecting them via DMX cables.
-> ENTER ->
CONFIGURE DMX START ADDRESS
Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo). Using the UP and DOWN buttons,
select the menu item "Addr" and confirm with ENTER and then again using the UP and DOWN buttons, configure the DMX start address as
required (the highest-configurable DMX start address depends on the selected DMX mode, the LED display "DMX" lights up and the DMX
mode is enabled). Confirm your entry with ENTER.
-> ENTER ->
8
-> ENTER ->
UP/DOWN
<- MODE
-> ENTER
UP/DOWN
<- MODE
-
-> ENTER ->
UP/DOWN
<- MODE
/
/
/
/
-> ENTER
UP/DOWN
<- MODE
-