Floor Tool - SEVERIN SEPURO HV 7184 Instrucciones De Uso

For appliances with dust bags
Changing the dust bag
∙ The dust bag can only hold a limited amount of dirt.
∙ Therefore, make sure you change the dust bag if the suction power drops noticeably or the dust level indicator lights up
red:
1. Make sure that the appliance is switched off.
2. Remove the tool and the suction tube.
3. Press the
4. Remove the cover from the dust container (see Fig. IV).
5. Remove the filled dust bag by pulling it upwards and dispose of it properly.
6. Insert a new dust bag following the direction of the arrow.
7. Replace the cover on the dust container and push it until you hear it click into place.
Attention! The dust container has a safety function that prevents incorrect insertion of the dust bag. If you cannot
mount the dust container back on the appliance, check that the dust bag has been inserted correctly.
8. Push the dust container back into the appliance until you hear it click into place.
Cleaning the HEPA filter
∙ The HEPA filter can get clogged due to soiling, causing the suction power to drop. Make sure you clean the filter on a
regular basis.
At the latest
∙ if the suction power seems to be reduced
∙ before storing the appliance for an extended period
∙ before sending the appliance to the service centre.
∙ Cleaning the filter:
1. Make sure that the appliance is switched off and is not charging.
2. Remove the tool and the suction tube.
3. Remove the HEPA filter cover underneath the handle by turning it counter-clockwise.
4. Pull out the filter.
5. Tap the filter out. If necessary, brush off with a small brush and tap out any loose dust.
6. Slide the filter back in.
7. Replace the cover and lock in place by turning clockwise.
Changing the HEPA filter
When normally used for household purposes, the filter should be replaced every 6 months.
Cleaning the brush roller in the floor tool and the upholstery tool
Soiling may prevent the brush roller from rotating freely. Clean the brush roller regularly.
1. Make sure that the appliance is switched off and is not on charge.
2. Remove the tool from the suction tube.

Floor tool:

3. Press the button on the side of the tool ( ). You can pull the brush roller out of the housing from the side.
4. Remove any hair and dirt from the brush, using a pair of tweezers or scissors carefully, if necessary.
Attention! Carefully use scissors within the brush roller groove to cut away any hair or debris wrapped around the
brush roller.
5. Slide the brush roller back into the tool. To do this, press the red button and slide the brush roller back in from the side
until you hear it click into place.
Upholstery tool:
3. Loosen the locking latch on the side of the tool by turning it counter-clockwise.
4. Remove the brush roller.
5. Remove any hair and dirt from the brush, using a pair of tweezers or scissors carefully, if necessary.
6. Slide the brush roller back into the tool, push it down and lock in place by turning clockwise until the lock engages
above the elevation.
button on the top of the appliance and remove the dust container by pulling it downwards.
17