Tabla de contenido
Publicidad
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(2)
1/2" W renches
(2)
7/16" W renches
(1)
Pliers
(1)
Hammer
1. Install a 5/16-18 x 2-3/4" hex bolt (17) and a 5/16"
jam nut (25) in each bag arm channel.
25
17
2. Slide the bag arm channels (4) into the sweeper
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). T ighten bolt until snug. Do
not overtighten.
All manuals and user guides at all-guides.com
4
FIGURE 1
15
4
21
FIGURE 2
3. Secure each bag arm channel to the side of the
sweeper housing with a plastic wing nut (31) installed
4. Insert a pivot rod retainer (30) down into the end of
5. Install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
31
6. Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using two washers (63), three 5/16" x 2-1/2" hex bolts
63
14
63
8
21
4
30
32
FIGURE 3
15
8
FIGURE 4
Publicidad
Tabla de contenido
