Publicidad
Step
Step 10
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (K2) to the RIGHT END (A2). Use the screws in the
å
HINGES. You should start each SCREW a few turns before completely
tightening any of them.
Insert two PULLS (77K) into four PULL MOUNTS (78K) and fasten them
å
to the DOOR (K2). Use four SILVER 5/8" MACHINE SCREWS (15S).
See the next step for DOOR adjustments.
å
SILVER 5/8" MACHINE SCREW
(4 used for the PULLS and MOUNTS)
www.sauder.com/services
All manuals and user guides at all-guides.com
15S
Stop
Mounting
screw
A2
K2
109830
Pro Tip: Lift with your
legs. And, you know,
your arms.
Hinge
78K
77K
78K
Page 15
Publicidad
