Publicidad
Idiomas disponibles
Idiomas disponibles
4. Insert EZ-Grip handle into top of pre-drilled sign pole
and align holes in pole with holes in handle. Most
signs require handle to be inserted fully.
(See Figure 2)
NOTE: For signs with hole 3" from top of sign,
use bottom hole on handle.
Figure 2
5. Attach top of sign to top hole in sign pole using
provided hardware. Place stabilizer plate between
back of sign and sign pole with flat side facing sign
and rails running along length of sign pole.
(See Figure 3)
NOTE: Mounting plate bolt will go through pole
and handle.
Figure 3
Sign
Stabilizer Plate
PAGE 2 OF 6
ASSEMBLY CONTINUED
EZ-Grip Handle
Bolt
EZ-Grip
Handle
Flange
Nut
6. Attach a stabilizer plate to end of mounting bolt
projecting out of sign pole and finger-tighten flange
nut. (See Figure 4)
Figure 4
7. Attach bottom of sign face to sign pole using
provided hardware. Follow same directions shown in
step 5.
NOTE: Wiggling the sign may be needed to
align holes that are on 3" centers starting 9"
from top hole.
8. Tighten flange nuts snuggly. Do not over-tighten,
crush or distort sign pole. Flange nuts have
serration's that will hold tight.
9. For two-sided signs, place second sign face
between back stabilizer plate and flange nut.
NOTE: For thick sign panels, a longer 5/16" bolt
may be required.
10. To move sign, grip handle, tip sign on its recessed
wheels and pull to roll. (See Figure 5)
NOTE: Unit accommodates all stock street,
safety, directional and other signs from 9" x 12"
to 24" x 24" along with custom-shaped sign
panels if they have 3" hole spacing.
CAUTION: Unit is designed to withstand winds
up to 3-40 mph. Bring sign inside or add more
ballast in event of higher winds.
Figure 5
1-800-295-5510
uline.com
0521 IH-9309
Publicidad
