Technical Information; Additional Information - Bellman & Symfon BE1470 Manual Del Usuario

Troubleshooting
Most problems with the pager can be solved quickly by following the advice below.
If Try this
The pager seems to be
 The battery is depleted. Replace it with a 1.5V AAA alkaline battery.
turned off
Important! If you have a pager charger, only use a rechargeable 1.2 V
AAA NiMh battery in the pager.
The battery LED blinks in
 The battery level is low. Replace it with a 1.5V AAA alkaline battery.
yellow
Important! If you have a pager charger, only use a rechargeable 1.2 V
AAA NiMh battery in the pager.
The pager does not respond
 Check the batteries in the transmitters.
when a transmitter is
 Move the pager closer to the transmitter to make sure it's within radio range.
activated
 Check that the pager is set to the same radio key as the other units in the
Visit system, see Changing the radio key in the Installer's guide.
The pager is activated for no
 There is probably another Visit system installed nearby that triggers your
apparent reason
system. Change the radio key on all units, see Changing the radio key in the
Installer's guide.
25

Technical information

Dimensions
H 86 mm (3.4") x W 57 mm (2.2")x D 29 mm (1.1").
Weight 70 g (2.5 oz.) incl. battery
Power supply
Mains power: 7.5 V DC 1500 mA via the BE1260 charger accessory
Battery power: 1 x 1.5 V AAA alkaline or 1 x 1.2 V AAA NiMH rechargeable battery
Power consumption Active: ≤ 220 mA, Idle position: ≤ 1 mA
Operating time Alkaline battery ~ 2–3 weeks, NiMH battery ~ 1week, fully charged
Activation Via Visit transmitter
Radio frequency 314.91 MHz, 433.92 MHz or 868.3 MHz depending on region
Coverage 50 – 250m (55 – 273yd) depending on radio frequency. Coverage is reduced by
walls, large objects and other radio transmitters.
In the box BE1470 Pager, Belt clip, safety cord and an extra front label
Accessories
BE1260 Pager charger, BE1270 Bed shaker
Environment For indoor use only.
Regulatory Fulfils CE, FCC & IC, RCM, Der Grüne punkt

Additional information

Operation, transport and storage For information, see the Installer's Guide.
Maintenance and cleaning Maintenance free. Clean with a dry cloth. Don't use household cleaners,
aerosol sprays, solvents, alcohol, ammonia, or abrasives.
Safety and regulations For information, see the Installer's Guide.
Service and support For information, see the Installer's Guide.
EN
26