Fcc Compliance Statement - Bellman & Symfon BE1470 Manual Del Usuario

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular in-
stallation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the follow-
ing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
113 Installer's guide
Industry Canada statement
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and Econo-
mic Development Canada's licence-exempt RSS(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
L' émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d' Innovation,
Sciences et Développement économique Canada appli-
cables aux appareils radio exempts de licence. L' exploitation
est autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d' en compro-
mettre le fonctionnement.
This Class B digital aparatus complies with the Canadian
ICES-003.
IC: 6693A-BERX
Installer's guide 114