General Notices - Bimar FS40R1 Folleto De Instrucciones

I signal that the height of the characters
(3mm) is only for "GENERAL NOTICES" and
for the letters high-lighted, as rule EN
60335-1:2012.
Fax +32 030 9904733
Please read these instructions carefully before using the
appliance, and instruct other persons using it, too, when
necessary. Keep booklet Hndy for further use.
If when reading this instructions manual certain parts
should remain difficult to understand, or if there is any
confusion, contact the company indicated on the last
page before using the product.
Attention: instructions and general notices for safety
use.
This symbol show: the appliance is class II equiment, for
which the power cord plug is without of the pole to the
ground.

GENERAL NOTICES

• This device is intended for home use only, to ventilate rooms, and
in the manner described in this manual: do not use it for any other
purpose. Any other use is to be considered inappropriate and
therefore dangerous. The manufacturer cannot be held
responsible for eventual damage caused by inappropriate,
improper or irresponsible use and/or for repairs made to the
product by unauthorised personnel.
This appliance is intended to be used in household and similar
applications such as:
- staff kitchen in shops, offices and other working environments;
- farm houses
- by clients in hotels, motels and other residential type
environments
- bed and breakfast type environments
• Do not touch the appliance with wet hands or feet.
• Do not insert any tool, or your fingers, into the grille protecting the
blades.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
9 40
/
Assembly page 9/40