Technical Data; Noise Information; Vibration Information - Worx Sonicrafter WX678 Manual Original

HYPERLOCK™ ACCESSORY CLAMPING
1.
LEVER
2. ON/OFF SWITCH
3. VARIABLE SPEED DIAL
4. VENTING SLOTS
5. UNIVERSAL-FIT ACCESSORY INTERFACE*
SMALLER FLANGE (FOR OTHER BRANDS'
6.
SANDING PADS)
7. FLANGE
*Works with other oscillating tool brands'
accessories.
The following compatible brands are
trademarks owned by third parties which may
be registered by their respective owners:
Bosch , Black & Decker
®
Not all the accessories illustrated or described
are included in standard delivery.

TECHNICAL DATA

WX678 WX678.9 (6-designation of
Type
machinery, representative of high frequency
oscillation tool)
Voltage
Oscillations speed
Oscillations angle
Tool weight
**Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
PA WA
Wear ear protection.
Oscillating Tool
, Makita and Fein .
® ® ®
WX678 WX678.9
20V Max**
5000-20000 /min
3.2°
1.4 KG
L : 76dB(A)
pA
L : 87dB(A)
wA
3.0dB (A)

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined
according to EN 62841:
a = 3.57m/s²
Vibration emis-
h
sion value:
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING:To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
9
EN