72
If a paired smoke detector is faulty, the red LED
By looking at the power LED
and the smoke detector LED
what is wrong. If you are using multiple smoke detectors, just enter the smoke detector
Error
Low battery
Lost connection
Hardware failure
Trouble shooting
Most problems can be solved quickly by following the advice below.
If
Try this
The smoke detector
indicates low battery
The connection is lost
There is a hardware
failure
light on the Flash receiver will start to blink.
you can easily identify
Indicaton
Power LED
Smoke detector LED
RED, blinking
AMBER
GREEN
AMBER, blinking
OFF
AMBER, blinking
The smoke detector
Replace the battery using the correct batteries
stated at the smoke alarm label.
Check if the battery in the smoke detector is
still OK.
Move the units to their original position and
verify that the error message disappers.
Clean the smoke detector according to the
smoke detector manual.
If it is still faulty, replace the smoke detector.
Removing one smoke detector from the system
BE1443
Press the Smoke detector Menu button
on the backside of the unit.
The Smoke detector LED
to indicate you are entering the menu system.
Press the Smoke detector Menu button
as many times as needed to reach the smoke
detector you would like to remove from the
system.
Removing all smoke detectors from the system
Press the Smoke detector Menu button
on the backside of the unit.
The Smoke detector LED
green to indicate you are entering the
menu system.
Menu
button
Smoke
detector
LED
Press and hold the Smoke detector
Menu button for more than 5 seconds.
will blink green
Release the button.
moval of the smoke detector by switching
between the orange, green, yellow and
red LED lights three times.
Menu
button
Smoke
detector
LED
To remove all smoke detectors in the
system, press and hold the Smoke detector
Menu button
will blink
Release the button.
moval of the smoke detector by switching
between the orange, green, yellow and
red LED lights three times.
73
BE1443
CZ
5 s
DE
Menu button
DK
ES
FI
FR
-
GB
GR
HU
IT
NL
5 s
NO
Menu
button
PL
PT
SE
for more than 5 seconds.
SRB
-
APP