Steam Function - Morphy Richards 47507 Manual Del Usuario

47507MEE Rev 2 14/12/06
6
16:33 Page 6
All manuals and user guides at all-guides.com
Note: If any part of the pod,
including the flap, is outside the
filter holder the sealing system will
not function properly. This will affect
the functioning of the machine and
the coffee quality.
Place the filter holder ‡ on the
4
brewing head fi and position
the handle so it points left.
Ensure the filter holder is flat against
the brewing head and turn the
handle towards the right I as far as
it will go.
5 Place a pre-heated cup below the
outlet holes of the filter holder J.
Note: One coffee pod has the
measured amount of coffee for one
single espresso. When the coffee is
at the correct temperature the
sign will be displayed.
6 Move the lever down to the coffee
setting. You will hear the machine
make a pumping noise, this is
normal.
7 Once the cup is filled to the desired
level, move the lever back to the off
position. Water will still filter through
for approximately 8 seconds after
the lever has been moved to the off
position.
8 Carefully remove the filter holder
by turning the handle slowly to
the left.
9 To remove the pod from the filter,
push the filter lock fl forward over
the edge of the filter and turn the
filter holder upside down, gently tap
out the pod L.
10 Once the sign shows, your
machine is ready to make the next
espresso.
Note: It is normal for the symbols
on the display to cycle on and off
during the water heat up process.

Steam function

The froth attachment makes it easy
to produce frothy milk for
cappucino.
Ensure the coffee/steam lever is in
the off position.
1 Before using the steam nozzle,
remove the filter holder.
www.morphyrichards.com
2 Attach the froth attachment È to
the end of the steam nozzle Í P.
IMPORTANT: For the froth
enhancing attachment to work you
must ensure that it is pushed firmly
onto the steam nozzle.
3 Fill the water reservoir with cold
tap water.
4 Swing the steam nozzle with the
froth attachment to the side of the
machine.
Press the steam button ‹, when
5
the unit is ready to make steam the
sign shows. This sign will flash
on the display until the machine
reaches the correct temperature to
make steam when it becomes fixed.
6 Pour cold milk into a suitable jug.
Use approximately 100ml for each
cappucino.
Note: For best results we
recommend to use refrigerated milk
and a stainless steel jug that is well
chilled.
7 Hold the jug under the steam nozzle
so that the head of the froth
attachment is immersed in milk and
push the lever up to the steam
setting Q. You will hear the
machine making a pumping noise,
this is normal.
IMPORTANT: Do not allow the tip of
the nozzle to touch the bottom of
the jug because this could obstruct
the passage of steam.
8 Once the froth has been produced
push the lever down to the off
position and remove the jug.
Note: Do not be alarmed by the
escaping steam from the base.
Note: It is normal to hear a pumping
sound when switching from steam
mode to coffee mode or hot water
mode.
The milk is ready as soon as it
forms a soft, thick layer of foam
on the top. If the milk starts to
make large popping bubbles, you
have boiled the milk and it will
therefore not froth. If this happens
replace with chilled milk. Do not boil
the milk.