Onkyo HT-RC660 Manual Básico página 15

Performing multi-zone playback
1.
Press ZONE2 on the remote controller, point the
remote controller at the remote controller sensor and
press zRECEIVER.
"Z2" stays lit on the main unit display and the multi-zone
function is enabled.
2.
Press ZONE2 on the remote controller again and
press INPUT SELECTOR of the input to be played in
a separate room.
To play the same source in the main room and separate
room, hold down ZONE2 for approximately 3 seconds. If
you turn the unit to standby during multi-zone playback,
the Z2 indicator is dimmed and the playback mode is
switched to playback in a separate room only. Performing
steps 1 and 2 while the unit is in standby also switches
the playback mode to playback in a separate room only.
To control on the main unit: Press ZONE2 and within
played in a separate room. To play the same source in the
main room and separate room, press ZONE2 twice.
To turn off the multi-zone function: Press ZONE2 on the
remote controller and press zRECEIVER. Alternatively
press OFF on the main unit.
Zone playback is not possible if the player and the unit
are connected via HDMI cable or digital cable. Connect
the player to the analog audio input jacks of the unit with
analog audio cable. Analog audio output setting may be
necessary on the player.
If ZONE 2 is on, power consumption during standby
becomes larger than normal.
If ZONE 2 is turned on when the listening mode of the
main room is Pure Audio, it will automatically switch to
Direct. (European model)
While ZONE 2 is on, the RI linked system function
(interlink between Onkyo components) is disabled.
All manuals and user guides at all-guides.com
Step 3: Playing Back
15