Safety Instructions - Bostitch BT1855 Manual Del Usuario

SAFETY INSTRUCTIONS

m IMPORTANT READ CAREFULLY: It is important that all operators read and understand all sections
of this Tool Technical Data manual and the separate Safety and Operating Instruction Manual which
come with this tool. Failure to do so could result in you or others in the working area to be seriously
injured.
m WARNING! Eye protection in accordance with 89/686/EEC, and with equal or greater grade than defined in
EN166 should be used. However all aspects of operators work, environment and other type/s of machinery being
used, should also be considered when selecting any personal protection equipment. Note: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
m WARNING! To prevent accidental injuries:
• Never place a hand or any other part of the body in fastener discharge area of tool.
• Never point tool at yourself or anyone whether it contains fasteners or not.
• Never engage in horseplay.
• Never pull the trigger unless the nose is directed towards the work.
• Always handle the tool with care.
• Use the Bostitch tool only for the purpose for which it was designed, such as: the finishing around doors,
windows and edging; draw bottoms, cabinet backs and cabinet making; picture framing and furniture trim.
These tools should not be used for anything other than wood to wood applications.
• Do not pull the trigger or depress the work safety yoke whilst loading the tool.
• To prevent accidental actuation and possible injury, always disconnect air supply.
1. Before making adjustments. 2. When servicing the tool. 3. When clearing a jam. 4. When tool is not in use.
5. When moving to a different work area, as accidental actuation may occur, possibly causing injury.
• Read the additional Safety & Operating instructions booklet before using tool.
• Do not use oxygen and combustible gases as an energy source for pneumatically operated tools.
• The operation of this tool can cause sparks and act as a source of ignition for flammable fuels and gases.
LOADING
m Warning! When loading the tool 1) Never place a hand or any part of the body in fastener discharge area
of the tool; 2) Never point the tool at self or anyone else; 3) Do not pull the trigger or depress the safety yoke as
accidental actuation may occur, possibly causing injury.
1. Depress magazine release button and pull back magazine. (Fig 1)
BT1855, BT1855SP
2. With magazine fully open, insert fasteners. Points must be against bottom of magazine. (Fig 2)
FN1650, FN1650SP
(Figs 1-3)
3. Push magazine forward. Continue pushing until latch is engaged. (Fig 3)
1. Depress magazine release button and pull back magazine. (Fig 4)
SX1838
2. Open magazine fully. Turn tool sideways with discharge area pointed away from yourself
SL540
& others. Load staples in channel. (Fig 5)
(Figs 4-6)
3. Push magazine forward. Continue pushing until latch is engaged. (Fig 6)
1. Load nails through the slot in the rear of the magazine and past retaining clip. (Fig 7)
FN1664
2. Pull pusher back behind nail stick and release. (Fig 8)
FN1664SP
3. Ensure magazine pusher is behind the last nail stick. (Fig 9)
(Figs 7-9)
FASTENER LOCK OUT (BT1855, FN1664, SX1838)
These tools employ a mechanism to prevent dry firing of the tool. When the magazine is not loaded with nails or
when the remaining number of nails becomes less than ≈10, the contact arm cannot operate and the tool will not
fire.
All manuals and user guides at all-guides.com
GB