Assembly; Disassembly And Scrapping - Pronomic Minimontacargas 65 Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 74

2 Assembly

Protective footwear should be used when assembling the lift trolley, to prevent injuries if parts are
dropped.
1. Place the wheel frame and cross-member on the floor.
2. Slide the column onto the bracket on the cross-member. The screw bar on the
bracket fits the slots on the back of the column.
3. Fit the power pack into the slot on the back of the column. Move it downwards until
it stops. Tighten the dome nuts/black knob. Plug the motor cable contact into the
matching socket on the power pack.
4. Fit the handlebar into the slot on the back of the column and lock it in a desired
height. Connect the remote control to its socket on the power pack.
5. Press the up button on the remote control to make the column go down to its lowest
position. The column should stand directly on the cross-member.
6. Tighten the nuts on the back of the cross-member, but not too hard (15 Nm), with a
13 mm wrench.
7. Attach the load carrier with the supplied screws and washers in the slide of the
column.
8. Perform a static load test, with 1.25 x the maximum load.
(Move the load carrier to the middle of the column and apply the load.)
9. The lift trolley is now ready to use.

2.1 Disassembly and scrapping

To disassemble the lift trolley, follow the instructions in section Assembly, but in reverse order.
When the lift trolley is due for scrapping the machine, complete with batteries, should be handed
in to a recycling centre or the distributor where you bought your device to ensure reuse and safe
handling of all parts.
________________________________________________________________________________
3 – Minilift 65 / 85 / 120

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Minimontacargas 85Minimontacargas 120

Tabla de contenido