Filter Removal And Installation; Important - RIDGID WD45500 Manual Del Usuario

SP6734 RIDGID WD45500 4.5 Gallon
4. Place the float over the opening in the
center of the lid with the words "This
side toward lid" laying face down over
the hole.
5. Line up filter cage tabs with the slots in
the center ring of the lid assembly.
Push on the filter cage until the tabs
snap into the slots for a secure fit.

Filter Removal and Installation

To install a new filter you must first
determine which filter attachment system
is used on your Vac.
The filter cage has a stud on the end with
either screw threads to receive a filter
nut, or the Qwik Lock™ ball end which
will allow the filter to snap into place
without a filter nut or other attachment
hardware.
The stud type will determine which of the
following sets of instructions should be
used.
!
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
IMPORTANT: To avoid damage to the
blower wheel, always reinstall the filter
before using the Vac for dry material
pick-up.
10/28/09
All manuals and user guides at all-guides.com
7
10:53 AM Page 7
Slots (3)
Labeled
End
Float
Tabs (3)
THIS SIDE
TOWARD LID
Filter
Cage
Threaded Filter
Cage
Screw
Filter
— OR —
Filter
Qwik Lock™
Cage
Stud
Filter