Gorenje S3 IHGC963ORAB Manual Del Usuario página 29

Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always
check that the mains cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.
Mounting
Very heavy product; hood handling and installation must be carried out by at least two persons. Before beginning
installation:
• Check that the product purchased is of a suitable size for the chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws
(*), guarantees (*), etc.), eventually removing them and keeping them.
• If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access
to rear wall/ceiling. Otherwise put a thick, protective covering over countertop, cooktop or range to protect
from damage and debris. Select a flat surface for assembling the unit. Cover that surface with a protective
covering and place all canopy hood parts and hardware in it.
• In addition check whether near the installation area of the hood (in the area accessible also with the hood
mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside
(only suction version).
• Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage
of the discharge tube).
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician
must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong
enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suc-
tion is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes
approximately after terminating cooking.
To select the functions of the hood press on the symbol. Function will be activated when symbol will be released.
T1. Standby mode
Note:
After about a minute of inactivity (suction and lights), the hood will automatically switch to standby.
T2. ON/OFF lights
On certain models only
press repeatedly to select the desired light intensity:
L1:
low light
L2:
medium light
L3:
high light
Press again to turn off the lights.
T3. ON/OFF Automatic operation "AdaptTech".
The hood automatically sets the suction speed (power) 1 to increase if the environmental conditions detected
by the hood sensor require it.
If there are no variations in the environmental conditions, after 10 minutes (if the hood is already in suction
speed (power) 1), the hood turns off.
Note:
for a correct use of this function, first perform the "Setting of the parameters for Automatic Operation"
(see corresponding paragraph).
Note:
During automatic operation, if the user acts on the other functions that adjust the speed, auto ventila-
tion function is switched off.
T4. Manual selection of the suction speed (power):
L4:
suction speed (power) 1
L5:
suction speed (power) 2
L6:
suction speed (power) 3
(the control panel off all functions disabled) /
(see drawing above):
ON
(control panel switched on)
EN 29