Inseego FW2000e Guia De Instalacion página 19

Connecting a device
You can connect any router or device with Ethernet capability and an internet browser
to the FW2000e. Connect an Ethernet cable from the Data In port on the PoE power
injector to the connecting device.
NOTE: Any time you switch the device you are connecting to the FW2000e, you must first disconnect the
existing connected device and power cycle the FW2000e before connecting the new device.
Monitoring and managing your FW2000e
You can use multiple options to monitor and manage your 5G Outdoor CPE:
– FW2000e Admin Web UI - Access the Web UI for a full set of device management
features. Typically, http://192.168.1.1 provides Web UI access, however under certain
conditions http://inseego.local/
NOTE:
You cannot connect to the Web UI through a router. Your computer must be directly connected
by Ethernet cable to the Data In port on the FW2000e PoE power injector.
– Inseego Connect - Go to connect.inseego.com to sign up for a free Inseego
Connect account, which lets you configure the settings, monitor status, and update
the firmware on your device. Additional functionality can be obtained with a
subscription to Inseego Connect Standard or Advanced.
– Inseego Mobile App - Use the same mobile app you used to install your FW2000e
for routine device monitoring and management.
*This local address relies on having IPv6 enabled on your connecting device.
is required. The initial sign in password is: "Fast5G!".
*
18