Samoa 363 053 Guía De Servicio Técnico Y Recambio página 4

EN
OPERATION
DISPENSING LOCK POSITION
To lock the trigger in dispensing position, proceed as follows:
1. Pull the trigger to its maximum opening (fig. 1).
2. Push the lock button (fig. 2).
3. Release the trigger holding the button down until it locks (fig. 3).
4. Once locked, release the trigger and the lock button. The trigger should remains locked, otherwise, repeat the process.
5. Once the desired quantity is dispensed, pull the trigger to its maximum position and release it. The button should
unlock and close the valve.
!
WARNING: Extreme caution when locking the trigger to avoid fluid spillage.
Fig. 1
SEMI-AUTOMATIC NOZZLE OPERATION
4
836 837 R. 09/20
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Fig. 3
Fig. 2
If the control valve is equipped with a semi-automatic
nozzle, opening is performed automatically pulling the
trigger, does not need prior manual opening.
The closing of the nozzle is done by sliding the outer body
of the nozzle to the gun until its stop.