MaxPro MPBDP16 Manual Del Usuario página 6

All manuals and user guides at all-guides.com
D D rill Press MPBDP16 User Manual
ROLL LONG SLEEVES ABOVE ELBOWS
a. If any part of your drill press is missing, malfunctioning, has been damaged or broken ... such as the
motor switch, or other operating control, a safety device or the power cord ... cease operating immediately
until the particular part is properly repaired or replaced.
b. Never place your fingers in a position where they could contact the drill bit or other cutting tool if the
workpiece should unexpectedly shift or your hand should slip.
c. To avoid injury from parts thrown by the spring, follow the instructions exactly as given and shown in
"SPINDLE RETURN SPRING" section.
d. To prevent the workpiece from being torn from your hands, spinning on the table, shattering the tool, or
being thrown, always support your work so it won't shift or bind on the tool.
(1) Always position "backup material" (used beneath the workpiece) to contact the left side of the column.
(2) Whenever possible, position the workpiece to contact the left side of the column — if it is short or the
table is tilted, clamp solidly to the table. Use table slots or clamping ledge around the outside edge of the
table.
(3) When using a drill press vise, always fasten to the table.
(4) Never do any work "free hand" (hand holding a workpiece rather than supporting it on the table),
except when polishing.
(5) Securely lock head and table support to column, and table to table support before operating drill press.
(6) Never move the head or table support while the tool is running.
(7) Before starting the operation, jog the motor switch to make sure the drill bit or other cutting tool does
not wobble or cause vibration.
(8) If a workpiece overhangs the table such that it will fall or tip if not held, clamp it to the table or provide
auxiliary support.
(9) Use fixtures for unusual operations to adequately hold, guide and position the workpiece.
(10) Use the SPINDLE SPEED recommended for the specific operation and workpiece material — check the
panel inside the pulley cover for drilling information; for accessories, refer to the instructions provided
with the accessories.
e. Never climb on the drill press table; it could break or pull the entire drill press down on you.
f. Turn the motor switch "OFF" and unplug from power source when not in operation.
g. To avoid injury from thrown work or tool contact, DO NOT perform layout, assembly, or setup work on
the table while the cutting tool is rotating.
h. Clamp workpiece or brace against column to prevent rotation.
i. Before starting, be certain chuck key is removed from chuck and that motor head and table are locked.
j. Keep pulley cover closed when not making belt adjustments.
k. Do not expose to rain or use in damp locations.
USE ONLY ACCESSORIES DESIGNED FOR THIS DRILL PRESS TO AVOID SERIOUS INJURY FROM THROWN,
BROKEN PARTS OR WORK PIECES.
(1)WHEN CUTTING LARGE DIAMETER HOLES:
Clamp the workpiece firmly to the table. Otherwise the cutter may grab and spin at high speed. Use only
onepiece, cup-type, hole cutters. DO NOT use fly cutters or multi-part hole cutters as they come apart or
become unbalanced in use.
(2)Drum sanders must NEVER be operated on this drill press at a speed greater than the speed rating of
the drum sander.
(3)Do not install or use any drill bit that exceeds 7" in length or extends 6" below the chuck jaws. They
can suddenly bend outward or break.
(4)Do not use wire wheels, router bits, shaper cutters, circle (fly) cutters, or rotary planers on this drill
press.
(5)Use recommended speed for drill accessory and workpiece material.
(6)Accessories must be rated for at least the spindle speed setting of the drill press. This drill press has 5
spindle speeds. Check spindle speed setting of the drill press based on pulley speed chart located inside the
6
GB