Bevel Heads - Bevel Tools Bevel Mite EBI-C 3.0 Instrucciones De Funcionamiento

3.1.1 Adapt flange head
i
• Turn the flange head (1) clockwise or counter-clockwise to set depth.
3.1.2 Protection of the machine
•Temperature-dependent overload protection. For protection against overheating, when a critical temperature is
reached, the electronic safety feature switches into the cool down mode. Then the machine continues to run at
approx.: 3.200 rpm and the electronic constant speed control is deactivated. After a cool-down time of approx.
10 - 20 sec. the machine is again ready for operation. Turn the machine off and back on again to activate the
electronic constant speed control. When the machine is at operating temperature the temperature-dependent
overload protection reacts correspondingly earlier time.

3.2 Bevel heads

Use only bevel heads whose admissible maximum speed is equal to or higher than the no load speed of the machine.
Use only clean bevel heads!
i 3.2.1 Placing / Changing a bevel head
• Remove the powerpack!
• Use the locking button to lock the spindle
• Use the Hex wrench (4 mm) to unscrew the guide bearing.
• Take the bevel head off.
3.2.2 Fitting a bevel head
• Before fitting the bevel head, clean the surface of the adapter and bevel head.
• If the adapter surface is damaged you should replace the sacrificial adaptor part (see 4.1.2) to prevent unwanted
damage to the cutters!
• Check the guide bearing, it should run smoothly, a guide bearing that doesn't run smoothly will damage the bevel
head and can lead to a broken bevel head.
• Place bevel head on the adapter. Make sure the notch (pinhole) on the cutters base fits precizely on the cylindrical
pin of the adapter. If this isn't done correctly the cutter might get damaged when using the tool.
• Use the locking button to lock the spindle.
• Use the hex wrench (4 mm) to tighten the guide bearing.
• Check if the bevel head runs smoothly and true, not true running bevel heads must be replaced immediately.
Check bevel tool before use. The bevel head must be correctly mounted and must rotate freely. Perform a trial run
over a period of min. 30 seconds without load. Do not use bevel heads which are damaged, which do not run true or
which vibrate!
All manuals and user guides at all-guides.com
EN
Flange head
Cylindrical pin
Locking button
4
Notch