Operating Instructions; Preventive Maintenance; Repair; Warranty - Bevel Tools Bevel Mite EBI-C 3.0 Instrucciones De Funcionamiento

3.3 Operating instructions

i
• To achieve an optimum bevel result, move beveling tool uniformly with light pressure.
• The electronic constant control maintains the speed nearly constant during idling and work under load and assures a
uniform result.
• Excessive pressure lessens the working capability of the machine, as well as the life of the bevel head.
• The machine is equipped with an electronic control and integrated overload protection.
• If the machine is overloaded, the speed will drop drastically. Immediately take the load off the machine and allow
to run for a short time without load.
• Maximum depth per cut, on steel, no more than 3 mm with a maximum power-on time of 50%.

4.1 Preventive maintenance

• To work effectively and safely, keep the machine and the ventilation slots clean at all times.
• To maintain the protective insulation the machine must be subjected to a technical safety inspection. This work
must be done exclusively by a specialized electrical workshop.
• When working on metal under extreme working conditions, conductive dust deposits can occur inside the machine,
thereby impairing the protective insulation of the machine. In such cases the use of a stationary vacuuming system,
frequent blowing out of the ventilation slots and protection by a fault current protection switch are advised.
• Take off the flange head regularly and clean the threads inside the flange head as well as on the machine.
4.1.1 Changing the sacrificial adapter
i
In order to ensure correct operation and extend the service life of the bevel heads, it is essential to ensure that the
surface of the adapter spacer is unblemished, i.e. without pits, deep scratches and\or broken edges. The adapter pin
should also be undamaged and retain its original length. The adapter spacer and/or adapter pin may get damaged
under certain conditions, however both can easily be replaced.
• Turn the flange head until it comes off.
• Remove the hex screw (C) on the side of the spacer (A).
• Then screw both M4 bolts (D), each time by a half-turn, deeper and
deeper in the spacer. This removes the spacer from the spindle (B).
• Remove the damaged spacer when it has become free. Unscrew the
two M4 bolts from the spacer you just removed and keep them.
• Install the new spacer, ensuring that it rests securely on the spindle
shoulder. Use a rubber mallet if necessary.
• Replace the adapter pin (E), ensuring the top is level with the top of
the spindle.
• Retighten the hex screw on the side of the spacer.

4.2 Repair

!
If despite strict observance of the manufacturing and testing method
the tool should happen to fail, it must be repaired by an authorized agency. Any replacement needed for the
connecting line must be installed by the manufacturer or its agent if safety risks are to be eliminated.
i

4.3 Warranty

Beveltools machines have been manufactured to quality standards and carefully inspected before shipment. The
warranty period for all Beveltools machines is 12 months from the original date of purchase. If repair is required,
the user must return the complete tool to the manufacturer or nearest authorized dealer. Complaints can only be
honoured if the machine is returned in the undissembled condition, with copy of the purchase invoice and clear
description of the problem. If inspection shows an original defect in material or workmanship Beveltools will repair or
replace the tool without charge during the warranty period.
The warranty does not apply to normal use or wear and tear. In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or if the service and maintenance instructions not being observed by
authorized persons, no warranty shall be in effect for damages/consequential damages.
Beveltools reserves the right to make changes or improvements to its products. Beveltools is not obligated to make
any corresponding changes or improvements in products previously manufactured or sold.
All manuals and user guides at all-guides.com
EN
5