Changing The Blank Holder - Amann Girrbach Ceramill Motion 3 Modo De Empleo

A P P L I C A T I O N A N D O P E R A T I O N
6.2

Changing the blank holder

In delivery condition, the milling machine is
E N
equipped with a 98 blank holder. For processing
varying materials, it may be required to use a dif-
ferent blank holder.
To change the blank holder:
▷ With the door closed, select
blankholder
machine.
The current tool is placed down. The blank
holder [2] moves to the change position.
1
Fig. 15 Changing-position of the blank holder
1 Fastening screw for blank holder
2 Blank holder
▷ Loosen fastening screw [1].
▷ Depending on the model, pull off the blank
holder toward the right or toward the bottom.
▷ Clean the locating bore and surfaces.
▷ Check the pin of the blank holder and clean if
required.
▷ Insert the blank holder with the pin to the stop
in the locating bore.
52
Service > Change
on the display of the milling
NOTE:
Inaccurate working results or damage to the
blank-holder fixture possible!
▷ Tighten fastening screw [1] with a torque of
4 Nm.
The torque wrench included in the delivery
scope is appropriately set.
▷ Tighten fastening screw [1] with with the sup-
plied torque wrench.
▷ Close the milling chamber door.
The machine moves to the starting position.
2