2.3
MOUNT THE MOTOR
1. Install the bracket (5) on the transom of the boat.
2. Tighten the clamp knobs (4) tightly.
CAUTION
Over-tighten the clamp screws can damage the bracket.
2.4
TILT THE TWIST TILLER
HANDLE
The twist tiller handle has five available positions.
The twist tiller handle is shipped in the down position. Pull
the handle tightly up to the horizontal position.
1. Pull the twist tiller handle (6) up to 15º, 30º or 45º
position.
2. Pull the twist tiller handle (6) down to 45º position.
NOTE
English
Press the handle release button (10) before you pull
down the handle.
2.5
ADJUST THE SPEED
The machine offers a choice of five forward and three reverse
speeds.
1. Turn the twist tiller handle (6) counterclockwise from O
(OFF) position to increase the reverse speed.
2. Turn the twist tiller handle (6) clockwise from O (OFF)
position to increase the forward speed.
2.6
INSTALL THE BATTERY PACK
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
•
Read, know, and do the instructions in the battery and
charger manual.
1. Press the door release button (12).
2. Open the battery door.
3. Align the lift ribs on the battery pack (11) with the
grooves in the battery compartment.
4. Push the battery pack (11) into the battery compartment
until the battery pack locks into place.
5. When you hear a click, the battery pack is installed.
6. Close the battery door.
2.7
REMOVE THE BATTERY PACK
5
NOTE
OFF
WARNING
EN