Maintenance; Replace The Propeller; Store The Machine; Troubleshooting - GreenWorks TMF301 Manual Del Operador

EN
1. Open the battery door (14).
2. Push and hold the battery release button (13).
3. Remove the battery pack (11) from the machine.
3

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
3.1

REPLACE THE PROPELLER

Remove the battery pack before any replacement or
maintenance.
1. Hold the propeller (8) tightly.
2. Loosen the prop nut (15) with a wrench.
3. Remove the prop nut (15) and washer (16).
4. Replace with a new propeller.
Make sure you align the slot (17) of the propeller with
the dirve pin (18).
5. Reinstall the prop nut and washer.
CAUTION
CAUTION
WARNING
WARNING
WARNING
English
Tighten the prop nut 1/4 turn past snug (25 - 35 in lbs.).
Don't overtighten the prop nut, it may cause damage to
the prop or cause too much pressure/strain on the motor
which may cause overheating or premature battery
drain.
3.2

STORE THE MACHINE

Make sure that the electrical parts are dry.
Make sure that children cannot come near the machine.
• Make sure the battery is removed.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• replace the damaged parts.
• tighten the bolts or nuts.
• speak to an authorized service center.
• Keep the propeller free of weeds and fishing line.
• Keep the leading edge of the blades smooth. If there are
nicks or rough edges, it is suggested to correct by using a
smooth file or fine sandpaper.
4

TROUBLESHOOTING

PROBLEM
Motor fails to run
or lacks power.
Motor looses pow-
er after a short
running time.
6
CAUTION
WARNING
WARNING
POSSIBLE SOLUTION
CAUSE
There are obstruc- The motor may
tions. have gone into
current limit. Turn
the machine off,
remove obstruc-
tions and restart
the machine.
You do not install Check battery con-
the battery pack nections for proper
correctly. polarity.
The terminals are Use a fine sandpa-
not clean. per or emery cloth
to clean the termi-
nals.
The battery pack is Charge the battery
out of power. pack fully.