Product Description - Comunello Automation INDEX INSERT EURO Instrucciones De Montaje

Thank you for choosing a COMUNELLO AUTOMATION
product.
This manual provides all the detailed information required for
the understanding and correct use of the equipment. It must
be read carefully at the time of purchase and consulted if
there are any doubts regarding its use or when maintenance
is required.
The manufacturer reserves the right to make any modifications
to the item and to this document without prior notice.
WARNINGS
Please read this manual carefully before beginning installation
and carry out the procedures as specified by the manufacturer.
This installation manual is only intended for professional
personnel.
Anything not expressly included in these instructions is
prohibited.
In particular, your attention should be drawn towards the
following warning:
• Disconnect power before making any electrical connections.

PRODUCT DESCRIPTION

Recessed selector switch with European key. The INDEX
INSERT EURO digital selector can be installed in outdoor
environments.
PRELIMINARY CHECKS
• Check that the item inside the packaging is intact and in good
condition.
The "H" insert (Fig. 3) is used for mounting on concrete and
must be positioned during the construction of the pillar. Pay
special care to the securing direction ("UP" arrow) when
routing the cable through the corrugated tubing (Fig. 6A).
ELECTRICAL SPECIFICATIONS
Contact rating
Operating temperature
IP protection rating
INSTALLATION AND ELECTRICAL CONNECTIONS
• Mounting on concrete: proceed as shown in Figures 5 and 6A
using the screws provided 3.5x19 mm.
• Mounting on metal: proceed as shown in the Figures
5 and 6B (screws not supplied).
• Turn the key counter-clockwise and remove the lock assembly
as shown in Fig. 5.
• Connect the cables from the control unit to the corresponding
terminal using the diagram in Figure 7.
• Turn the key counter-clockwise and reinsert the lock assembly
as shown in Fig. 8.
• Clip the cover back on the base by first resting the top and
pressing downwards (see Fig. 9).
BOARD REPLACEMENT
If required, replace the card as shown in Figures 12-13-14.
DISPOSAL
A number of components of the item can be recycled
while others, such as electronic components must
be disposed of in accordance with the regulations in force in the
country of installation.
A number of components may contain pollutants that must not
be released into the environment.
3A 125V AC
-10°C – 55°C
54
11
CH1 C CH2
12
13
14